3dprinter-udev-rules-0.2.2-7.fc36.noarch

Normally, when you connect a RepRap like 3D printer to a Linux machine by an USB cable, you need to be in dialout or similar group to be able to control it via OctoPrint, Printrun, Cura or any other control software. Not any more.

Install this rule to grant all users read and write access to collected devices based on the VID and PID.

Disclaimer: Such device might not be a 3D printer, it my be an Arduino, it might be a modem and it might even be a blender. But normally you would add your user to dialout and get access to all of those and more anyway. So I guess be careful when some of the users should not get access to your blenders.